[split] Fail to start the emulator (was How to install application on emulator ...)

[manojsachdeva]

Hi

I am facing a problem.
After I run program under Carbide, the emulator starts and within a few seconds, it terminates emulator and does not install my application on it.

Please give a solution.

[kiran10182]

Hi

I am facing a problem.
After I run program under Carbide, the emulator starts and within a few seconds, it terminates emulator and does not install my application on it.

Please give a solution.

1) Are you able to launch emulator from command prompt? with "epoc" command?
2) Does this problem happen when you debug your application?
3) Which is the SDK and which is the version of Carbide.c++?

[yogpan]

Hi,
Have you tried building your project from command line for the winscw also?? Try this and then launch epoc and check whether your application is launching or not.

[ltomuta]

Compiling an application is one thing, running it in the emulator is quite another.

If the compilation failed there is no reason to start the emulator. If the compilation succeeded then the application is very likely "installed" in the right place.

You seem to have a problem running the emulator so you should focus on that issue first.

Also, your problem has nothing to do with the discussion that was taking place in the thread where you have posted your question.

To help you address these issues please read the links in my signature.