Emulator Installation gives error 'Menu: System error (-2)'

[ranjeetk]

Hi
I am getting 'Menu: System error (-2)' while running my S60 3rd FP1 UI application
Dis:
Created an UI application using carbide,
Compiled and generated SIS for Emulator WINSCW,
Signed with developer cert for 000000000000000 IMEI,
Installed Successfully on S60 FP1 Emulator,
: But when i try to launch application from emulator
it through an error Menu: System error (-2).
Note:
The same application is running if i launch the emulator from carbide
I can also run the application well on device(N82).

Please help me out... thanks...

[Priju Jacob Paul]

Where did you place the exe file and the resource files? Just make sure that these files are placed in the respective emulator paths.

- Priju

[ranjeetk]

This is the PKG i am using

; standard SIS file header
#{"DigitalClock"},(0x200259BA),1,0,0

;Supports Series 60 v 3.0
[0x101F7961], 0, 0, 0, {"Series60ProductID"}

"$(EPOCROOT)Epoc32\release\$(PLATFORM)\$(TARGET)\DigitalClock_0x200259BA.exe" -"!:\sys\bin\DigitalClock_0x200259BA.exe"
"$(EPOCROOT)Epoc32\data\z\resource\apps\DigitalClock_0x200259BA.rsc" -"!:\resource\apps\DigitalClock_0x200259BA.rsc"
"$(EPOCROOT)Epoc32\data\z\private\10003a3f\apps\DigitalClock_0x200259BA_reg.rsc" -"!:\private\10003a3f\import\apps\DigitalClock_0x200259BA_reg.rsc"
"$(EPOCROOT)Epoc32\data\z\resource\apps\DigitalClock_0x200259BA.mif" -"!:\resource\apps\DigitalClock_0x200259BA.mif"
"..\help\DigitalClock_0x200259BA.hlp" -"!:\resource\help\DigitalClock_0x200259BA.hlp"

; Add any installation notes if applicable
;"DigitalClock.txt" -"!:\private\200259BA\DigitalClock.txt"

"..\pictures\0.jpg" -"!:\private\200259BA\0.jpg"
"..\pictures\1.jpg" -"!:\private\200259BA\1.jpg"

;required for application to be covered by backup/restore facility
"..\sis\backup_registration.xml" -"!:\private\200259BA\backup_registration.xml"

[ranjeetk]

Ahh!
After some RND i got it:
In WINSCW build DigitalClock_0x200259BA.mif was not build to "$(EPOCROOT)Epoc32\data\z\resource\apps\DigitalClock_0x200259BA.mif" but it was to "$(EPOCROOT)Epoc32\release\$(PLATFORM)\$(TARGET)\\z\resource\apps\DigitalClock_0x200259BA.mif".
It was taking gcce build from "$(EPOCROOT)Epoc32\data\z\resource\apps\DigitalClock_0x200259BA.mif"
so using "$(EPOCROOT)Epoc32\release\$(PLATFORM)\$(TARGET)\\z\resource\apps\DigitalClock_0x200259BA.mif" it is fixed.