Unresolved breakpoint when running on device debugger

[rami75lu]

Hi,
When I set a breal point in my code and run on device debugging the breakpoint blue icon turns into yello with the following text
Multiple markers at this line
- Unresolved breakpoint
- Line breakpoint: WebClientEngine.cpp
I'm using carbide 2.0 and trk 3.1.2 with N78.

Any help will be really appreciated.

Regards

[swtdol]

I am also encountering the same problem. Someone pls help!!

[wizard_hu_]

Just for completeness: according to an other thread, Swtdol is asking about E71 and uses Carbide.c++ 2.7.

What SDK are you using? Version of TRK may also matter (does it connect properly? Are you using USB or BT?). What about the application, does it start on the device in general, just can not be debugged? Where is that particular breakpoint?

[swtdol]

yes,connection is made properly and i am using trk v3.2.1,sdk for S60 fp2 v1.1.On emulator debug,breakpoints work fine and application breaks but on target debugging,whenever i attempt to insert a breakpoint ,it results out to be unresolved

[swtdol]

I am using USB connection

[wizard_hu_]

Note that the original E71 is an S60 3rd edition FP1 device: http://www.developer.nokia.com/Devic...fications/E71/
Using S60 3rd FP2 may result in mysterious issues, including problems with debugging.
There is an S60 3rd FP2 model with very similar look and name, but that is called E71x (http://www.developer.nokia.com/Devic...ications/E71x/), and the two are different.

[swtdol]

I had tried it using sdk fp1 also,but that is also not working for me

[swtdol]

I got solution to this. Used RDebug::RawPrint instead and it worked. Thanks for ur help

[wizard_hu_]

Good to hear that. Unfortunately I can not check debugging with an E71 because I do not have one.