PANIC EXEC 3 while using a popup field into selection list mode.

[anand_zain76]

Hi,
After I have run following form to have a popup field.
when I press enter/click on the popupfileld box it gives panic KERN EXEC 3

RESOURCE DIALOG r_myform_multipage_dialog
{
flags = EEikDialogFlagNoDrag | EEikDialogFlagFillAppClientRect |
EEikDialogFlagNoTitleBar | EEikDialogFlagButtonsRight |
EEikDialogFlagCbaButtons | EEikDialogFlagNoBorder;
buttons = R_AVKON_SOFTKEYS_OPTIONS_BACK;
form = r_myform_first_form;
//pages = r_myform_pages;
}

RESOURCE ARRAY r_myform_pages
{
items =
{
PAGE
{
//id = EMyFormPageCtrlIdPage01;
text = "Page1";
form = r_myform_first_form;
},
PAGE
{
//id = EMyFormPageCtrlIdPage02;
text = "Page2";
lines = r_myform_second_form;
}
};
}

RESOURCE FORM r_myform_first_form
{
flags = EEikFormEditModeOnly ;
items =
{
DLG_LINE
{
type = EAknCtPopupFieldText;
prompt = "select";//"select";//qtn_options_form_label_accessPoint;
id = EOptionsFieldAccessPoint;
itemflags = EEikDlgItemTakesEnterKey | EEikDlgItemOfferAllHotKeys;
control = POPUP_FIELD_TEXT
{
popupfield = POPUP_FIELD
{
width = 10;
//other = qtn_aknexpopfield_list_other;

};
textarray = r_setting_list_item_array;
active = 0;
};
}

};
}


plz help

Thanks
ANAND

[cool_li]

This panic is raised when an unhandled exception occurs. Exceptions have many causes, but the most common are access violations caused, for example, by dreferencing NULL. Among other possible causes are: general protection faults, executing an invalid instruction, alignment checks, etc.

so you should find out whether the new and delete is matching.