help me start

[a21120060]

hello again,
i'm really going desperate with the carbide c++ compiler, since i'm used to visual studio where everything smoothly opens, while in this compiler, i can't even open an existing project like "btpointtopoint" because using the function import, it says (can't really understand why though...) that to import a file system i have to already have an opened project in the workspace. This is probably a very stupid question, but until now i'm stuck on templates, and not really familiar with this compiler so would gladly apreciate any kind of help you could give me.

Thanks a lot for the replys so far,
Jorge

[wizard_hu_]

You should set the workspace to some other location than the S60Ex folder of the SDK. Preferably to a new and empty folder somewhere (use Switch Workspace... in the File menu).

[everyourgokul]

Hi
did u tried the import mmp file option?