Open Signed Online-Why can not I submit .sis file?

[yfw1966]

Hello everybody,

I have completed basically my project code. now I am ready to test it on a device. because it includes some system capabilities as well as user capabilities. I am proceeding with 'Open signed Online' step by step.

1.Selecting all capabilities shown in the form, actually, only some of them are necessary to the current project. but I am not sure if the capabilities left will be included later.

2.navigating to the SIS file of the application.

3....
at last, it shows 'Application file is too large' in the top of symbian signed page. what's wrong with it?
Can anybody give me any clew? Thank you very much!

Best regards!
Sophie

[yfw1966]

I have tried it several times again. and it always shows:
"Application file is too large
"

How can I do? Anybody help me please!

[kiran10182]

I have tried it several times again. and it always shows:
"Application file is too large
"

How can I do? Anybody help me please!

Check this: http://developer.symbian.com/forum/t...4272&tstart=61

They are saying that limit is upto 4 MB. You may need to split your Sis file.

Kiran.

[yfw1966]

They are saying that limit is upto 4 MB.

But actually my sis file is only 46KB large.I will go to the link right now. Thanks very much!

[yfw1966]

unfortunately, there is no answer found there.
Can you give me any other advice? thanks very much.

[kiran10182]

unfortunately, there is no answer found there.
Can you give me any other advice? thanks very much.

We cannot do anything else other than waiting.

By the way do you have Publisher ID? I guess not, if you have then you might have gone for Open Signed Offline mode.

Kiran.

[Paul.Todd]

You might also have a corrupted sis file. Make sure you are signing the ARMV5/GCCE versions of the sis file and not the WINSCW version

Mark sure all binaries in the sis file are GCCE/ARMV5 as well

[yfw1966]

Mark sure all binaries in the sis file are GCCE/ARMV5 as well

I build my project with carbide c++. and also create the sis file with GCCE configuration. Anything else I need do to make sure that?

Thanks.

In addition, I think there should be other error information shown if it is the error of sis. but not "Application file is too large ". Do you think so?