sdk problem

[rkmohanty]

hi , i am using carbide.c++ ide, when i am importing one apllication(s60 2nd ed appli) under 7.x os . path is just like this C:\Symbian\7.0s\Series60_v21_CW\xyz.bld, its compile fine , but when i try to run that application , the s60 3rd ed emulater is running instead of 2nd ed emulater.

ya one thing i let you know , that xyz application is created under codewarrior ide , its working fine in codewarrior,
but not in carbide ,

what is reason behind it , anybuddy can help me out.

[kiran10182]

hi , i am using carbide.c++ ide, when i am importing one apllication(s60 2nd ed appli) under 7.x os . path is just like this C:\Symbian\7.0s\Series60_v21_CW\xyz.bld, its compile fine , but when i try to run that application , the s60 3rd ed emulater is running instead of 2nd ed emulater.

ya one thing i let you know , that xyz application is created under codewarrior ide , its working fine in codewarrior,
but not in carbide ,

what is reason behind it , anybuddy can help me out.

Can you check which SDK is set as default? Type "devices" on command prompt.

Kiran.

[RB_Sahu]

Hi,

You can check and change the default SDK by using this link.

http://www.artima.com/weblogs/viewpo...?thread=222217

[skumar_rao]

if you donot like using commandline try using sdkswitcher . http://wiki.forum.nokia.com/index.ph...n_SDK_Switcher

[rkmohanty]

ya i have checked with command in command prompt,

i.e:-
devices
after that i did set with command
devices -setdefault @Series60_v21_CW:com.nokia.series60

still its not working

[skumar_rao]

i think you are using Carbide.C++ v1.3 which donot support pre-v3.x SDKs so try down-grading to v1.2 or try Hack provided in wiki.

[rkmohanty]

i am using carbide.c++ v1.2

[ltomuta]

Check your project's Run/Debug Launch configuration and define a new one for the 2nd Edition SDK if needed