Where to write code of 'mobile turn off' inside 'sms example'

[rhondodedron]

Hello there,

I am a student and for my project have thought of making an application which responds to certain specific SMS Commands sent to a mobile phone.

For this, I have downloaded the SMS Example provided by Forum Nokia and tried to understand it.
Now, i have also got the code snippet to fake key presses and enable mobile turn off via an application.
The problem is - how do i integrate the two things ?
Where should i write the 'turn of' code snippet in the SMS example ??
I have checked out the part of the SMS example code in which it recieves and extracts message data, but i do not kow how to proceed with checking the message body for a specific command and then runnning the 'turn off' mechanism.

Any help from anybody who reads this will be highly appreciated !!

Thank you.

[nuker85]

Hello,
You could also try to use this part of code:
http://wiki.forum.nokia.com/index.php/SMS_Receiver
http://wiki.forum.nokia.com/index.ph...SMS_from_Inbox

You have got it commented and you should easily figure out what to do

Good luck

[ssn.kishore]

Hello,

If you have understood the SMS Example I am sure you know what EMsvEntriesCreated means.

In the following code snippet, I've given you the line where you can read the body of the message.

case EMsvEntriesCreated:
		{
			TMsvId* entryId = static_cast<TMsvId*>(aArg2);
	
			CMsvEntrySelection* entries = static_cast<CMsvEntrySelection*>(aArg1);
			if(entries)
			{
				CMsvEntry* entry = 0;
	
				for(TInt index = 0; index < entries->Count(); index++)
				{
					entry = iSession->GetEntryL(entries->At(index));
					entry->OwningService();
					CleanupStack::PushL(entry);
	
					if(entry->Entry().iMtm == KUidMsgTypeSMS)// Incoming SMS
					{
						if ( *entryId == KMsvGlobalInBoxIndexEntryId )  
						{
							if(entry->Entry().iDetails.Compare(_L("FromYourConcernedNumber")) == 0)
							{
								
							entry->Entry().iDescription; // This is the body of the message. You can do whatever you want after comparing it to some of your "commands"
							}
						}
					}
					CleanupStack::Pop(1);
				}
			}
		}
		break;