Qt for S60 3rd edition FP2?

[samdutton]

[Oops -- apologies for multiple posting -- just put this in the general C++ board and on qt-interest, having forgotten about this forum...]

I'm trying to create a Qt project for S60 3rd edition, FP2, using the Carbide IDE, using 4.4.4-temple.

I've installed S60_3rd_FP2_SDK_v1.1 and I can build helloworldbasic and see the SDK in the the list of available Symbian OS SDs in SDK Preferences in Carbide.

However, when I try to create a Qt project and get to the Build Targets page of the New Project wizard, 'Filter build configurations that don't contain Qt support' filters out all but S60_5th_Edition_SDK_v0.9.

Can I create Qt apps for S60_3rd_FP2_SDK_v1.1?

Sam Dutton

[james1980]

Hi Samdutton,

Your question is not clear. Can you please explain it a better. Do you have both sdk install on your pc.

Regards

[james1980]

Hi samDutton

I think if carbide shows only 5th edition sdk in the availabel sdk then you can make the project for 5th edition only. When you run the project in which emulator it shows the output?

Regards.

[Sorcery-ltd]

Hi Sam,

Have you built the Qt binaries for winscw for both SDKs. I think Carbide just looks for the .lib files to link against.

Mark

[james1980]

Hi Sam,

Have you built the Qt binaries for winscw for both SDKs. I think Carbide just looks for the .lib files to link against.

Mark

hi,
I am agree with sorcery, you have to configure qt for both sdk ( 3rd and 5th ).

[samdutton]

Thanks for the replies.

I hadn't copied the qtlibs stuff to 3rd edition FP2 SDK.

I got confused by the instructions in section 5 of Installing Qt on S60:

The Qt libraries comes pre-built for real devices. To install them, execute qtlibs-4.4.4-temple.exe included in this package. Follow the install instructions and navigate to the root directory of the S60 SDK you are using. For example: C:\Symbian\9.2\S60_3rd_FP1_2\

What this means is that you have to extract qtlibs-4.4.4-temple.exe to the epoc32 folder of the SDK you're using, for example C:\S60\devices\S60_5th_Edition_SDK_v0.9\epoc32.

Sam

[Sorcery-ltd]

Hi,

Please note that you still need to build for the emulator for each SDK you want to use (unless you don't want to use the emulator). I guess it looks for Qt libs for any build because just the emulator libraries will pass the filter, even if you haven't extracted the target binaries.

Mark