[moved] Cannot step into QT Source Code in QT Creator Debugger

[ghassett]

Hello,

I have a stock installation of QT Creator on Mac OS.

All is well, except that I cannot step into the QT source code when needed (I am debugging a thorny problem with a subclassed QSortFilterProxyModel).

Do I need to set certain paths and/or settings before I can step "into" QT source with the debugger?

Thanks!

Greg

[skumar_rao]

Hello,

I have a stock installation of QT Creator on Mac OS.

All is well, except that I cannot step into the QT source code when needed (I am debugging a thorny problem with a subclassed QSortFilterProxyModel).

Do I need to set certain paths and/or settings before I can step "into" QT source with the debugger?

Thanks!

Greg

Are you talking about QT4S60 or Qt In-general ?

[ghassett]

Hi - it's Qt proper, version 4.5, open source edition. I downloaded a single package for my Mac which installed Qt and QtCreator. The installation was performed like a normal software application (I did not have to build Qt from source).

[skumar_rao]

Hi - it's Qt proper, version 4.5, open source edition. I downloaded a single package for my Mac which installed Qt and QtCreator. The installation was performed like a normal software application (I did not have to build Qt from source).

I think you are in wrong forum, this DiBo is dedicated to Nokia Mobile Platforms,

[ltomuta]

See http://www.qtsoftware.com/developer/...22e191ccf300d6