Carbide 2.0 Problem

[pornima]

Hi All,

I had installed carbide 2.0. i created dll & build(ARMI) for SDK 2.1 version, it gives me error
UID out of range
so i changed UID3 to 0x01000000. but this dll is not loaded....

is carbide 2.0 not compatible for All sdk? What is the problem?


Thanks & Regards,
Sheetal.

[skumar_rao]

Hi All,

I had installed carbide 2.0. i created dll & build(ARMI) for SDK 2.1 version, it gives me error
UID out of range
so i changed UID3 to 0x01000000. but this dll is not loaded....

is carbide 2.1 not compatible for All sdk? What is the problem?


Thanks & Regards,
Sheetal.

carbide 2.1 only supports SDK starting from v3.x . you need to use carbide v1.2

[pornima]

carbide 2.1 only supports SDK starting from v3.x . you need to use carbide v1.2

Hello,

I ask about carbide v2.0? it is also not compatible?

Sheetal.

[symbianyucca]

maybe you could try using the UIDs from the defined ranges, here's one Wiki article that shows the ranges: http://wiki.forum.nokia.com/index.ph...d_applications

[skumar_rao]

Hello,

I ask about carbide v2.0? it is also not compatible?

Sheetal.

yes it is not compatible with v2.x SDKs

[pornima]

yes it is not compatible with v2.x SDKs

I change UID3 to one of uid from carbide1.1. sis file is created. but load dll is failed with -1....
so any solution exists to use carbidev2.0 for SDK2.1?or i have to shift to Carbide v1.1?


Regards,
Sheetal.

[skumar_rao]

you have to use Carbide v1.2 or below

[wizard_hu_]

Actually the templates are still present in Carbide.c++ v2.x, so the method described in Lucian's blog (http://blogs.forum.nokia.com/blog/lu...carbide.c-v1.3) may work.