Is there anyway to unload an imported module?

[forumz]

Hi,everyone.
Is it possible to unload an imported module?

[croozeus]

Hi,everyone.
Is it possible to unload an imported module?

Try this,

import modulename

#do something here

del modulename

#the module is not accessible here

[forumz]

Try this,

import modulename

#do something here

del modulename

#the module is not accessible here

Thank you. But it is not like unload the module.
Here is my test:
On N78 v30 rom after importing misty, using appuifw.app.set_exit()or sys.exit() will hang up the program. So I try to del misty before exit the program, but it hangs up again. So I think it is not really unload the module.

There's another way to unlock / lock keypad except using misty??

[the86hitman]

thats the only way i know to remove the module from memory too. isit definitly those two lines that cause the program to hang? i assume you commented those two lines out and ran the code without it crashing?

you can try pykeylock, but thats only available for pys60 1.4.5

[forumz]

thats the only way i know to remove the module from memory too. isit definitly those two lines that cause the program to hang? i assume you commented those two lines out and ran the code without it crashing?

you can try pykeylock, but thats only available for pys60 1.4.5

Thanks, I tested several times, misty cause the program to hang. Using pykeylock everything's ok now.

By the way, where can I download your Project hStandby? I'm using E63 and python 1.45. Can I use it?

[the86hitman]

Thanks, I tested several times, misty cause the program to hang. Using pykeylock everything's ok now.

By the way, where can I download your Project hStandby? I'm using E63 and python 1.45. Can I use it?

my project hStandby I've put on hold while I wait for last few extensions to be ported to 1.9.x .
it is based on 1.4.5, and the last release (still very buggy) I made available at another forum - I shall PM you with the details incase i'm not allowed to post it here.