Make .sis file with QtCreator

[exitlol]

Hi,
How i can make a .sis or .sisx file with Qt creator ? I have to import my project to Carbide.c++ but is not working.

Thanks for your help.

[pta0007]

These are the steps how I make the sis file:
"running the qt for symbian command prompt;
cd to the file of your project
qmake
make release-gcce
make sis"

that's it. Then you can get the .sis file.

Good Luck!

[danhicksbyron]

I've not tried it on Creator, but under Carbide you have to set up the "build configuration" -- specify the PKG file. I'd give you chapter and verse except that I'm in the middle of uninstalling/reinstalling everything.

[axeljaeger]

If you try to run the application on your device from creator, it will create the .sis files, at least if you have a device connected.

[exitlol]

These are the steps how I make the sis file:
"running the qt for symbian command prompt;
cd to the file of your project
qmake
make release-gcce
make sis"

that's it. Then you can get the .sis file.

Good Luck!

Hi, thanks for your answer.

When i follow your command i have 4errors with makefile.
But if i make my project with Qt creator i have no error.

If you try to run the application on your device from creator, it will create the .sis files, at least if you have a device connected.

I have connect my n97 and config Qt Creator but i have error with message "No phone connected".

I have screen my Qt Creator config, and upload here.

Thanks again for help me.

[exitlol]

Any one for help me ?

[danhicksbyron]

On Carbide, in order to create a .sis file, you must edit the properties of the project and select "Build Configuration" (shown under the "Carbide.c++" category).

There you select the phone (vs emulator) configuration and the "SIS Builder" tab. Pressing "Add" on that tab gives you a SIS Properties screen. You must fill in the PKG file name on that screen. (The rest can default.)

I don't know how much this procedure resembles what goes on with Creator.

[exitlol]

I try create a .sis with QtCreator on my laptop, and it's work.
So i think my pc have a bad configurations.

My problem are resolved, thanks again for help me

[vladest]

Hi,
How i can make a .sis or .sisx file with Qt creator ? I have to import my project to Carbide.c++ but is not working.

Thanks for your help.

just add "make sis" build step in Qt Creator's Projects tab for the project

[carlos_navento]

just add "make sis" build step in Qt Creator's Projects tab for the project

I have that option when I use QT Creator 2.01, but when I use QT Creator 2.1 I don't have it. Does anybody knows how to activate it?

[carlos_navento]

Found, it was in the Deploy screen instead of the make one.

[nassern51@ovi.com]

apply the best for my Nokia C7