Remote signal strength

[Nokia_Archived]

Posted by Colm Breathnach, colmbreathnach@intactasoft.com
on February 25, 2002 at 11:09

If you are placing a data call to a remote terminal, n20 or n30, is there a way to read the signal strength at the remote terminal?
I can read the signal strength at the near end ok, (AT+CSQ), but can I get the remote to send me the signal strength at the distant end? I don't want to change the remote programming, so I need to do it all at the near end. Any ideas?

[Nokia_Archived]

Posted by Forum Nokia Developer Support,
on February 28, 2002 at 18:09

You can get the signal strength from the terminal in the M2M system mode by programming this logic to the server side application. Remote AT command will not work.