has anyone got the debug monitor on a 3650 to work

look in the sdk under:
» Developer Library » Base Porting Guide and Reference » Porting the base » Debug monitor » Using the debug monitor

this is what you must do:

Using the debug monitor

--------------------------------------------------------------------------------

Starting the debug monitor
If the Kernel or a system process panics, or if there is an unhandled processor exception, the Kernel beeps 4 times and enters the debug monitor.

To use the debug monitor:

Plug the mains adaptor into the DC jack.

Connect the machine serial port to your PC and set the PC serial port to 115200 baud, 8 bits, no parity, 1 stop bit, XON/XOFF flow control.

Press the ON key on the machine.

Start a terminal program on the PC (e.g. HyperTerminal.)

Press RETURN on the PC. The machine should reply

Password:
Enter the password "replacement" (all lower case, without the quotes). The machine should now reply

*** DEBUG MONITOR ***
You are now ready to use the debug monitor.



looks simple, but doesn't work for me

thanks


martijn