BMCONV tool in series 60.
On invoking BMCONV tool from the command line, the error stating "Bad command file" is generated.
Following is the command i had given in the command prompt..
bmconv /hcamtimer.mbg camtimer.mbm camtimer.bmp
and the following is the error message i am getting
BMCONV version 103.
Multiple bitmap store type: File store
Epoc file: camtimer.mbm
Bitmap file 1 : camtimer.bmp
Bad command file.
Is this the problem with the bmconv tool or the perl??
I could generate the bmp from a mbm file using the same tool. But not viceversa...
Posted by Naveen HM, firstname.lastname@example.org
on February 08, 2002 at 13:24
RE: BMCONV tool in series 60.
Posted by Camille Guermonprez-Brouard, email@example.com
on February 08, 2002 at 17:51
Hi, forget that lame BMConv version,
get that older version on: