Problem with 1001status code in Nokia Activ Server 2.1

[irene42]

Hello,
I have installed Nokia Activ Server 2.1 on my computer (standalone intallaton), Nokia Activ Alert and Nokia Mobile Internet Toolkit 3.0. I have managed to send a MIME type push message to the Toolkit using Activ Alert's example Push Initiator but when I try to send the same push message using my own Push Initiator I get the 1001 status code with the description "Accepted for processing". When I look at the Server's logs there is no indication that the Server accepted the message and I can't see the message on the Toolkit. Could you please help me?
Thanks,
Irene

[shalex]

Hello Irene,

there are several things which got to be checked:
1. Configure (or check if configured) bearer for push:
- check "Puch Functionality Allowed" box (bearer properties),
- add valid prefixes (for example +358 - finland, 127 - fist octets from localhost ip-addresses - for push via UDP)
(NACS Manager->Traffic Brokers-><your traffic broker>-->UDP bearer-->Push)

2. Add network types for push
- for UDP bearer (you're pushing to Toolkit, right?)
Any Any IPv4
Any Any IPv6
(NACS Manager->Traffic Brokers-><your traffic broker>-->UDP bearer-->Network types)

3. Check if push subsystem started and has
user_filter=PassAllPolicy in server policy

Add sample push initiator to Server Filter list:
The name of sample PI is NokiaActivAlertPI
Set PassAllPolicy for this PI
(NACS Manager-->Push Subsystems--><your push subsystem>-->Server Filter)

Push connector can be created and started on "Configuration" tab for Push Subsystem
(NACS Manager-->Push Subsystems--><your push subsystem>-->Configuration)

4. Use WAP Toolkit to receive Push messages:
- start wap toolkit (enable Push message receiving in WAP toolkit!)
- start sample Push Initiator: java -cp "lib/pgw.jar" etc etc etc... :) (check Activ Alert guide for complete launch command)

5. Send push message with sample PI

P.S. Remember please to mark Auto-activate checkbox in Toolkit's "Push" tab (Toolkit->Push tab->Auto-Activate)