How to access internet in the emulator of Series 60?
I try to config the emulator by setupcomms.
i have followed the below instruction to configure my emulator:
run setupcomms and choose item a) Modems:
Set PortName to COMM::<port-number>, e.g. COMM::0 for COM1.
Set TSYName to MM
Set CSYName to ECUART
But when i try to use the dial-up service in the emulator, the emulator just keep on trying to establish the dial up connection.....
My computer have no com port!!
Last edited by ccwhk; 2004-11-04 at 14:55.
Then you need to create a virtual COM port. There is a software from www.eltima.com that is able to create ones in your PC. The license is a little bit expensive (unfortunately).