Failed Compiling using SIP v4.0 in ARMI

[RyanSantos]

After installing the SIP Plugin v.4.0 for Codewarrior I successfully compile, run and test my SIP app. Now when I compile it for ARMI, I get the following errors

Could not find or load the file "SIPCLIENT.lib" for target "ARMI UREL"....

for SIPCLIENT.lib, SIPPROFILE.lib, SIPPROFILECLI.lib, SIPCODEC.lib, and SDPCODEC.lib. I checked the <S60SDKPATH>\Epoc32\release\armi\urel and could not find the files. I tried uninstalling and installing the SIP Plugin and it still does not install the required files. SIP Plugin 3.0 do not have those errors.

[kriipine]

Hi,

This issue does not relate to CodeWarrior IDE but here comes a reason:

The reason is in Sip Plugin. The version 4.0 does not contain ARM platform at all. You can only compile Thumb platform.

[RyanSantos]

So would Thumb executables or apps work in N6680?

[smpme]

I've the same problem.
Does anybody know how to get SIP apps working in a device?

[smpme]

Solved:
Just copying the missing *.lib 's from thumb to armi gets the job done

[RyanSantos]

Actually it seems that both Thumb and ARMI executables work on the N6680

[KevinD]

ARMI binaries can be used on THUMB devices without a problem.
However, THUMB binaries cannot be used on ARMI devices.

As far as I know, all Series 60 devices up to v2 FP3 are THUMB devices.

Always use THUMB in preference to ARMI where you can - THUMB binaries are on average smaller (around 10% if I recall correctly).